1. 095031-6340 Fuel Injector Valve Rod Technical Support

1.1. 095031-6340 Fuel Injector Valve Rod Measuring Tools

1.2. 095031-6340 Fuel Injector Valve Rod Measuring Steps

No.	1	2
Image
Description	Step 1: Choose caliper: CRT085	Step 2: First open the caliper (OFF/ON), then return the display (ZERO) to zero ▲The caliper must be adjusted to zero before measuring.

1.3. 095031-6340 Fuel Injector Valve Rod Storage Standard

(1) Choose a Suitable Storage Place

The warehouse and cargo yard where the fuel injector valve rods are stored should be kept clean and dry, and away from the factory buildings that generate harmful gases and dust; do not mix with acid, alkali, salt and other substances; the storage place should have a good drainage system; the cargo yard should be flattened with gravel or furnace ash etc. to enhance the water permeability of the surface layer to keep the reservoir area dry.

(2) Strict Requirements of Warehousing

Strict inspections should be carried out when the fuel injector valve rods are put into storage, the surface cleaning work should be done well to remove water traces, oil stains, ash and other dirt, remove the rust and do anti-rust treatment in time. Packaged fuel injector valve rods must be protected from damage.

(3) Keep The Warehouse Dry And Preventing Moisture

The relative humidity is usually below 70% for the fuel injector valve rods placed in the room, and the corrosion of the fuel injector valve rods is significantly reduced.

Fuel injector valve rods must be stored in the warehouse, and they are forbidden to store in the same warehouse with commodities with high water content.

(3) Stack Properly

After the fuel injector valve rod is exposed to rain, the corrosion rate will increase significantly. The purpose of sealing is to isolate the fuel injector valve rod from rainwater and humid air, so the warehouse window should be checked in time to avoid rainwater entering the warehouse

If the fuel injector valve rod package is damaged, it should be repaired or replaced; when the package is damp, the packaging material should be dried; if the original anti-corrosion and oil applied at the factory is found to be damaged or dried up, it should be cleaned and re-applied oil in time.

It is forbidden to leave the fuel injector valve rod exposed in the air for a long time.

It is forbidden to store acid, alkali, salt and other substances together with the fuel injector valve rod.

The unpacked fuel injector valve rod must be rust-proof during secondary storage.

2. Copyright Statement

The content, design, and images on this passage“095031-6340 Fuel Injector Valve Rod Encyclopedia” are the property of www.fueinjectorvalverod.com and are protected by copyright laws. This passage is intended for personal use and may not be reproduced, distributed, or transmitted without the express permission.If you have any questions about this copyright statement or wish to obtain permission to use content, please contact us at hison@shumatt.com.